Scan a photo of your wood pile or a live-edge slab into your project
Published on
Photograph the lumber, offcuts, or live-edge slabs you already own. Sawdust extracts each piece, matches standard sections to your regional material pack, and carries the real wood grain through every cut.
Many workshop builds start with the wood already leaning against the wall or stacked on a cart: an L-shaped remnant of 3/4-inch plywood, a few framing lengths, a short 2x6 offcut with one mitered end, or a live-edge slab waiting for the right table design.
Choose Insert -> Scan my wood to turn a photo into modeled stock you own, complete with actual grain from the photo if you like. Sawdust straightens each piece out of the photograph, measures its dimensions, matches dimensional boards against the profiles in your selected regional material pack, and adds the accepted pieces to your project.

Reconstructing dimensions from clues in the image
When you lay boards on a whole sheet of plywood, or on the floor with a sheet of letter or A4 paper among them, Sawdust uses the sheet or paper to solve the camera height, lens, and tilt automatically. Every board in the photo is projected onto the floor plane and compared against the stock cross-sections in your project's material pack.
If a piece has an angled cut on one end, lay it on its edge if it is a bevel so the angle is visible to the camera. Sawdust detects angled ends and brings the offcut in with its miter or bevel already shaped.

Notice that the 2x4, 2x6, and 1x2s in the photo above are lying directly across the plywood sheet. When a board crosses another piece, Sawdust reconnects the split mask underneath, removes the overlying boards and their shadows from the lower sheet's image, and fills in the wood grain from the surrounding grain.
Toggle Match wood grain from photo before clicking Add pieces to wrap each board's straightened photograph onto its 3D geometry as owned stock.

Trace a live-edge slab from a single measurement
When you photograph a slab leaning against a rack without a reference sheet, the scan finishes and offers Add a known measurement.
Click and drag a line on the photo, such as the top and bottom ends of the slab, and type the measured distance between them. Sawdust reads the vertical lines in the background to determine how far the phone was pitched, places the slab plane, and traces up to 400 corners along the natural live edge to within a single pixel.


Cut, resaw, and join scanned wood in the shop
Scanned boards and slabs behave like any other lumber in Sawdust. Because they are added as owned stock, they are excluded from the purchase shopping list unless you run short, and their photo grain stays locked to the wood through every operation in your timeline.

For a George Nakashima-inspired live-edge coffee table and bench, the scanned 77-inch slab is brought onto the workbench, mortised for splayed through-tenon legs, and inlaid with two contrasting walnut butterfly keys across the natural check at the wide end and the bark inclusion at the neck.
